Mounting of the Panel, wilba CS and TK case

[Polykobol]

Hello,

Is there somewhere on the forum an explication about how is mounted the CS pcb with the Front Panel and with the same case TK uses?

Also, what is the value in mm of the distance between the PCB and the front panel?

Where did you get these "distance" bolt?

Best regards,

PK

[offe]

Hi,

I believe you will find the answers to your questions in the wikipage here: http://www.midibox.org/dokuwiki/doku.php?id=wilba_mb_seq_construction_guide

best regards

offe

Edited December 26, 2012 by offe

[orange_hand]

Hi,

 

you can also check out the following thread: http://www.sequencer.de/synthesizer/viewtopic.php?f=13&t=70858

 

The description is in German, but there are a lot of pictures. Please note that I have modified the front panel with some profiles at the ends of the front panel. This was necessary to prevent the front panel to move when the sequencer is turned up side doiwn :-)

I will finish this thread soon, as I have now received my rear panel. Once my sequencer is complete, I will update the WIKI with my tutorial.

 

Cheers

orange

Edited January 21, 2013 by orange_hand