Parts required/not required for slave cores and slave sids in multiSID MBSID?

[Mr modnaR]

hello all,

i found nebula's question relating to what is not needed on slave cores/sids, but iwas wondering if everything was mentioned in that thread?

basically, what components do not need to be mounted on the slaves.

thanks in advance. :)

[TK.]

Maybe you could create a list of components you want to use, and somebody else can say, which ones are not really required - you could write this into the Wiki in order to ensure, that the same question doesn't need to be answered again and again...

Best Regards, Thorsten.

[Altitude]

I only mounted the J11, the clock, and the resistors (probably more than i needed). The big cap, rectifier, small cap in the power circuit can go if your running 5VDC from your PSU.  I think I also left off the opto (my box is at my shop so i'll verify)

[Mr modnaR]

Maybe you could create a list of components you want to use, and somebody else can say, which ones are not really required - you could write this into the Wiki in order to ensure, that the same question doesn't need to be answered again and again...

Best Regards, Thorsten.

cool yes i will do that. cheers tk

[Mr modnaR]

I only mounted the J11, the clock, and the resistors (probably more than i needed). The big cap, rectifier, small cap in the power circuit can go if your running 5VDC from your PSU.  I think I also left off the opto (my box is at my shop so i'll verify)

i was going to leave off the large and small caps, but wasn't absolutely sure they weren't needed, but they'll come off now, thanks for the tip.

[Mr modnaR]

on my master core i've mounted:

PIC

Opto coupler

all resistors

all caps (except C4 and C5)

Q1

T1 (is this needed if i power my backlight directly from the power supply?)

J2 (for power)

J10 (for SID)

J15 (for LCD)

J4 (for bankstick)

J8+J9 (for DIN+DOUT)

J11 pins MO and VS

on my slave core, i've mounted:

PIC

all resistors

all caps (except C4 and C5)

Q1

J2 (for power)

J10 (for SID)

J11 pins MI and VS

now i need to know is that all correct? do all the resistors need to go on. (i know some don't on the slaves, but i'm not sure which ones. cheers people.

[Mr modnaR]

@Altitude:

if you didn't mount the large cap C5, why does it say that that cap should still be there in the c64 psu pdf?  ???

[Altitude]

I'm sure its to beef up the 5 volt signal but even on the schematic it says you can go lower value if you need more room

[Mr modnaR]

ok, cheers mate.