Guest nomadicWhale Posted April 4, 2003 Report Posted April 4, 2003 Hi,Bought a new crystal for mios. it reads:10.000ECSIs this good for the core?I downloaded the bootstrap and burt it to the pic. I expected the "F0 00 00 7E 40 00 01 F7" message to aprear (using midi-ox) but it doesn't.The core worked fine with the 16F and the 20.000. Any ideas?Thanks
d2k Posted April 4, 2003 Report Posted April 4, 2003 If it's a parralell cut one yes, if series no...BestDan
Guest nomadicWhale Posted April 4, 2003 Report Posted April 4, 2003 How can I tell if it is a parallel or serial cut?
d2k Posted April 4, 2003 Report Posted April 4, 2003 Not sure, try asking the place u got it from...BestDan
Guest nomadicWhale Posted April 5, 2003 Report Posted April 5, 2003 to my great disappointment they didn't even know what I'm talking about...Anything else I can do to verify the type of the crystal I have?
Guest pkstone Posted April 5, 2003 Report Posted April 5, 2003 (How to tell parallel from series crystals)It wasn't immediately obvious to me either, but in the Digikey catalog, I noticed that crystals were either labeled "series", or given a capacitance value (e.g. 18 pF) in the column "load capacitance". The ones that aren't labeled series are the parallel ones.I have a question, though. What is an acceptable load capacitance for the 18F 10 MHz crystal? I see one in Digikey (part #X443-ND) that has a load cap. of 18 pF. Is that okay, or does it call for an adjustment to the value of the caps connected to the crystal in the MBHP core schematic?Phil Stone
TK. Posted April 6, 2003 Report Posted April 6, 2003 The only way to verify the crystal is to use an oscillator and a scope, or to ask the manufacturer :-/ However, the PIC should run with a different frequency, that means: a LED hooked to MIDI Out should flicker during startup. Just only the MIDI receiver will not regognize the MIDI events because of the baudrate mismatch.Capacitance of the crystal: doesn't really matter here, it's only relevant for radio applications. 15 pF are fineBest Regards, Thorsten.
Guest nomadicWhale Posted April 6, 2003 Report Posted April 6, 2003 Most of the people that sell electronics don't know the nuance (series/parallel cut). They know only one type of crystal and it is with series cut. :-[Well, at least I know the problem is with the crystal and not with somthing else.
Guest nomadicWhale Posted April 11, 2003 Report Posted April 11, 2003 bought a new crystal and it works. ;D
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now