Hey Jerome
So I am just starting to plan a MidiBox NG and I would like to include these rotary encoder PCBs. I'm not sure right now whether I'll go for 16 or 24 channels, but I think they'll be in banks of four, so using 16 channels as an example I would need :
MB-LR4x2CS_RED x 4
MB-E4x2CS x 4
25MM shaft encoders 32 (though I see you sell them in multiples of 25)
Is that correct?
Is there any advantage or disadvantage of using MB-LRE8x2CS instead of MB-LR4x2CS_RED except that the LEDs are pre-soldered on the MB-LR4x2CS_RED modules? Of course, each board is 8 channels instead of 4, but apart from that and the pre-soldered LEDs, are there any differences?
Thanks,
DD