I feel like my V4L is really close to working, but for some reason it is not.
MIOS32 and the SEQV4L program are installed on the LPC, and I can connect to it in MIOS Terminal. However, I'm getting no results from any keypresses and rare intermittent flashing from the LEDs if any activity at all on the SEQV4L board. As far as I can tell, my ribbon cables have correct continuity and placement, and J15_S is in the 5V position.
The only thing I can see that might be amiss is that J5A/B's A5, A6, and A7 don't show any signal when I probe them with a scope, whereas A0-A4 show some activity. Is this normal? It persists when swapping the ribbon cables I'm using for J5A and J5B as well, so I don't think it's a cable issue.
I've double-checked all of my soldering and don't see anything amiss on the CORE and SEQV4L boards.
Any suggestions? I'm stumped at the moment.
-Sam