MB--6852 headphone jack / passive out? [resolved]

[m00dawg]

On the main wiki page for the MB-6582 (http://www.midibox.org/dokuwiki/doku.php?id=wilba_mb_6582&s[]=mb&s[]=6582) it says I need to solder some wires in order for the passive headphone output to work. But in looking at the schematics and the board, I see tracks running after each resistor to the next resistor and to the headphone jack header.

So I'm a bit confused :) Do I need to solder wires then and if so, where exactly?

[m00dawg]

Nevermind - I just noticed that the tracks are there for the SmashTV version of the MB-6852 mainboard (which I have) but not on the original V1 prototype board.

[pingosimon]

So did you have to solder anything, or is J7 0 ready to go? I was just reading up on this very topic.

[Smithy]

Hehe, nevermind should be banned on here!

There will always be people wondering the same thing,

that will mind to see the solution! :thumbsup:

[pingosimon]

Nevermind, I got it :tongue:

A quick test showed me that, yes, J70 is all wired up and outputs sound without any extra soldering.

[Wilba]

I often wonder whether it's worth making different revisions of PCBs (and fixing past stuff-ups) or just be consistent. :rolleyes: