Help
So I notice a lot of the new eurorack modular psu's are switching supplies. Anyone know how they are getting these to work well for analog circuits? I have a nice small +5, +/-12v switcher that would fit in my MBSEQ case, but I'm afraid it will cause problems. Anyone think this will work since its just producing modulation cv and not audio range signals?
Thanks,
Luke
Page 1 of 1
Switching supply for MBSEQ + CV
Rate Topic:
#1
- MIDIbox Addict
-
- Group: Programmer
- Posts: 134
- Joined: 07-January 05
- LocationPittsburgh, PA, USA
Posted 20 January 2012 - 16:46
#2
- MIDIbox Guru
-
- Group: Administrators
- Posts: 11,141
- Joined: 01-January 01
- LocationGermany
Posted 21 January 2012 - 21:20
See also this topic: http://midibox.org/f...post__p__144912
If you should notice some noise, just insert 10 ohm resistors between the PSU and the analog circuit + el.caps after the resistors. This seems to help!
Best Regards, Thorsten.
If you should notice some noise, just insert 10 ohm resistors between the PSU and the analog circuit + el.caps after the resistors. This seems to help!
Best Regards, Thorsten.
Buy TK a Beer Disclaimer: buying TK a beer gets you absolutely nothing in return likesuchas firmware enhancements, technical advices and MIDIbox troubleshooting assistance.
Share this topic:
Page 1 of 1