Jump to content

Power issue with MB6582


ChinMuzik

Recommended Posts

I am currently trying to upload the MIOS app to preflashed PIC and for some reason the core is not communicating. I did the MIDI loopback and communication workup and everything is ok. 

 

So I checked the PIC socket for 5v and they are receiving 5v fine on necessary pons and GRD os ok too.

But I noticed when checking voltages that the 9v and 12v pins do not receive proper voltage. 5v is consistent but 12v will show .45 and 9v about 4.5v most of the time....very rarely will I see full 9v and 12v on the pins (or SID socket)

What could this be? Is this possible a bad PS?

Link to comment
Share on other sites

Could you plot your 9/12V inputs by scope and send a picture? It will show the input signal,if not well regulated or whatelse.
Reminder,there is a jumper to set for each SID to set 9 or 12V input,if not set.

I sometime noticed on some (bad) PSU that when current is almost 'inexistant' Voltage does not raise to its correct level.
Maybe trying again with some Resistor/LED plugged serial from voltage pin to ground and check voltage again?

Edited by Psykhaze
Link to comment
Share on other sites

The scope is showing a straight line on all rails. Even the 5v rail I cannot see a waveform, however, I test the 5v rail and all the sockets with a multimeter and it is supplying the 5v.

I'm testing from the test point pin headers. 

I tested the 9v and 5v pins on the power supply and took screenshots of those.

 

 

20160910_030817_017_01.jpg

20160910_030605_010_01.jpg

Link to comment
Share on other sites

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...