AINSER configuration (Aftertouch)

[tago]

Hi,

 i get note values instead of numbers when i press aftertouch.

[397400.935] d0 64   Chn# 1  Aftertouch E-6
[397400.937] d0 63   Chn# 1  Aftertouch D#6
[397400.938] d0 61   Chn# 1  Aftertouch C#6
[397400.939] d0 60   Chn# 1  Aftertouch C-6
[397400.940] d0 5e   Chn# 1  Aftertouch A#5
[397400.942] d0 5c   Chn# 1  Aftertouch G#5
[397400.943] d0 59   Chn# 1  Aftertouch F-5
[397400.944] d0 42   Chn# 1  Aftertouch F#3
[397400.945] d0 16   Chn# 1  Aftertouch a#1
[397400.946] d0 14   Chn# 1  Aftertouch g#1
[397400.947] d0 00   Chn# 1  Aftertouch c-2

Here my NGC config

EVENT_AINSER id=6  type=Aftertouch  chn= 1  range=0:127  offset=0  ports=1000100000001000  lcd_pos=1:1:1  label="^std_aser"

 

Shouldn't it look like this? (note the numbers after Aftertouch)

[397400.943] d0 59   Chn# 1  Aftertouch 21
[397400.944] d0 42   Chn# 1  Aftertouch 34
[397400.945] d0 16   Chn# 1  Aftertouch 57
[397400.946] d0 14   Chn# 1  Aftertouch 29
[397400.947] d0 00   Chn# 1  Aftertouch 16

 

Thanks in advance!

 

[FantomXR]

Same here. But it seems to be correct. I've used it a lot already. 

[tago]

Thanks for looking into this.

So far i've only tested with MIOS studio and was a little irritated by this. I'm looking forward to testing it in a real world setup.

[TK.]

Yes, I think it's only a display problem in MIOS Studio, I should change this to a decimal value.

Best Regards, Thorsten.

[tago]

Thanks Thorsten!

[tago]

...

Edited October 7, 2019 by tago
opened new thread

[tago]

...

Edited October 7, 2019 by tago
opened new thread

[tago]

new thread:

 

Edited October 7, 2019 by tago
opened new thread