Leaderboard

Okay, so I just checked the cables: no problem, obviously. I also unsoldered / soldered back ic2 and ic3 together without success. The problem is 100% identical on both lemec pcb. Under MIOS, when I turn the knobs, I have a correct return of the values from both boards with the debug mode enabled, but no action is triggered when I press one of the buttons (alp push or lemec switches). Out of curiosity, I tested the pcb lemec (the smallest) by completely removing IC3 and the problem is the same, maybe that can confirm that IC3 is dead ? In your opinion, does this mean that certainty both IC3s are dead (because of the inversion?) and does the problem with the matrix also correspond to these ICs? I am waiting for your answer and I will order some spare parts. Have a good day and thanks :)

Hello, This is no. #4! ;) Inside the beast: Note , power/USB connection is not based on Micro-match here cause I used a first version wCore I already own. So this one is little bit customised. The MEC switches: I used 5GTH920+1LS096-15.0 instead of 3FTH9+1S11-16.0. + In this series, without smd led model accept regular 3mm led. The led is easy to install. The 1LS caps is made for that too. Like for the 3FTH9 model, led must be bent like this. Switch has specific position for the led's legs. The Soft Touch knob https://www.thonk.co.uk/shop/sifam-soft-touch-encoder-knobs/ I was obliged to adapt it to flush the surface. Without modification they are 5mm under the surface :/ Then first I made a wood support to be able to mill it precisely. Before milling: After: Result is perfect, at pushed position the knob fits inside the hole of the case. A 5mm diameter led window. For that purpose I used a special cast acrylic for led diffusion https://www.trotec-materials.com/laser-materials/acrylic-sheets/troglass-led.html Surface of the beat led will be plane, colour is homogenized in the entire hole, clear led are usable and placed under. ... The two screens are regular LCD(not OLED) cause I had it in stock, but it's definitively the next update. They are not low profile then ribbon must be soldered directly to the LCDs, no enough room for the connectors. I replaced the IIC Board by a MCAN connector(RJ11) and 2 DIN Sync Outputs. I will not use the expansion board for the moment then I put a blank plate. Voilà! This is my SeqV4+ I got no problem to build this big box, with Peter's tutorial it's a child game. I strongly recommand to follow his tutorial cause there's a lot of tips you have to know and you can't guess! In general this is a very well though and designed project, the case is very precise, if you follow the instruction all will fit perfectly. The final result is beautiful, awesome :) Thanks to Andy, Peter, Adrian and Thorsten for their time, their effort and their passion! Thanks guys for that gift, I love it!!!!!! Best regards Bruno