t_xen Posted August 30, 2008 Report Posted August 30, 2008 ok. I figured I have the Left and Right SID modules wired up to the core correctly, because I am getting audio from both left and right channels. but the audio produced (no matter how much tweaking I do through the menu interface) it still comes out as mono. My mixer has a left and right audio level readout and I am getting audio from both channels, however there is no noticeable difference between the channels. I use a stereo cable that splits to left and right channels that plugs into my mixer. On the output, continuity checks out by testing the Tip to the right module and the Ring to the left module.Not sure what to do at this point. any insight?Thanx Quote
/tilted/ Posted August 30, 2008 Report Posted August 30, 2008 What happens if you mute /disconnect the left channel?What happens if you mute /disconnect the right channel?Are you sure your mixer channel is stereo? Many stereo mixers have mono inputs... Quote
m00dawg Posted August 30, 2008 Report Posted August 30, 2008 I would also recommend loading up one of the example Drum Sequencer patches since they produce different sounds on the left and right channels (SIDs) so you can see if you are, indeed, hearing both SIDs. Quote
DenDer Posted August 30, 2008 Report Posted August 30, 2008 And if you plug in both SID, l & r separatly into your mixer does that work? This seems like a connection of audio line problem. Are you absolutly sure you soldered both SID audio channels right? Quote
t_xen Posted September 7, 2008 Author Report Posted September 7, 2008 ok, I did a double check on the audio wiring.I have the "Tip" (left output = bottom sid)and the "Ring" (right output = top sid)connected to the appr. pins of the stereo jack.The Top Sid Board (J2) is 1 to 1 on the Core (J10) except on the Top Sid board (j2-pin9) connected to (j14)........Oh, crap. I just saw the prob. blank pin conected to nothing. let me adjust the wiring on my 10 pin IDX connector. ::)moving a wire over...My cabeling on the sid has 3 connectors on it like a montherboard to a slave HD an master HD, But rather than that, it's a left and right channel. Quote
t_xen Posted September 7, 2008 Author Report Posted September 7, 2008 yup. I moved 1 wire over on the IDX and now it's in stereo. (core to sid)that's what I get for looking into the details. ;D Quote
DenDer Posted September 7, 2008 Report Posted September 7, 2008 :D Okay dan, nice dude that's it working....... Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.