orange_hand Posted July 21, 2012 Report Share Posted July 21, 2012 (edited) Hi, Today I tried to load the SEQV4 firmware into the CORE32 but there was no response. The USB connection was established and the MIOS Studio stated that the core is ready for the upload. I started the upload of the "project.hex" but there was no response from the core. MIOS Studio dumped a warning into the message log: Do I need to set a specific jumper in order to upload the firmware. I read the manual a couple of times but I couldn't really find an advice. Cheers orange Edited July 21, 2012 by orange_hand Quote Link to comment Share on other sites More sharing options...
orange_hand Posted July 21, 2012 Author Report Share Posted July 21, 2012 I was able to load the SEQV4 firmware to the Core32 after the selection of the appropriate device "00" [not "01" :-)] But thanks for looking indeed :-) Cheers orange Quote Link to comment Share on other sites More sharing options...
orange_hand Posted July 21, 2012 Author Report Share Posted July 21, 2012 First tests with some components are fine, but where is my control surface !?!? :-) Cheers orange Quote Link to comment Share on other sites More sharing options...
Shuriken Posted July 21, 2012 Report Share Posted July 21, 2012 Good to hear you got it working. And also nice to see my Core32 is put to use :wink: Quote Link to comment Share on other sites More sharing options...
Hawkeye Posted July 21, 2012 Report Share Posted July 21, 2012 (edited) You´ve definitely already got that famous MBSEQ four-four time C-3 beat going :) Edited July 21, 2012 by Hawkeye Quote Link to comment Share on other sites More sharing options...
wicked1 Posted July 22, 2012 Report Share Posted July 22, 2012 Where'd you get the SD card PCB? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.