Jump to content

Ainser64 configuration


macsaif

Recommended Posts

This is not a big problem, because I can add one Ainser8 module in higher resolution. The problem is that I need an additional 16 AOUTs. Other solution will be that I set all the inputs for higher resolution, but in that case I will have problem with jittering of all AINs. In 8 bit resolution rhe jittering is not an issue but in 10bit mode it will ne. 

Edited by macsaif
Link to comment
Share on other sites

Hello

 You don't need a second one ! assuming you talk about midi resolution ?

Set your AINSER module at 11bit in NG, and set event type= according to your requested resolution (7 or 14bit)

NG should scale

1 hour ago, macsaif said:

but in that case I will have problem with jittering of all AINs

With proper design and dedicated ref regulator you should go up to 11bit

Best

Zam

 

Link to comment
Share on other sites

The control panel is 90cm wide. Some pots will be 70cm from the 4051. Most probably I will do the connection with moltiwire flat cable directly from potentiometers to the AINSER board. Do you think can I manage this distance and solution without jittering in 11bit mode? 

Is there a possibility to manage 1 Ainser64 board and 16 Aouts by one STM32 board (MBNG)? 

Link to comment
Share on other sites

Hello

 

Can't say... you have to try in your design

Here I run aprox 35cm wire and trace from 10 to 25cm, with 3 connector in the path, from pot to AINSER input pin

Vref have dedicated regulation.

No jitter at 11bit

Side note, I use AINSER8, no multiplexing, can't say what is the noise introduced by switching nor if there is some.

 

IIRC you can chain AOUT up to 4 TLV (32 out) with a single RC line,

so yes, 64in/16out is possible at J19

 

Best

Zam

 

Link to comment
Share on other sites

I think that I will make 2 AIN modules, one AINSER64 to connect the less important pots with 8 bit reolution and one AINSER8 to connect the high resolution pots (VCF freq, VCO detuning, LFO freq). The AINSER64 is tested with longer cables(80cm) in 8 bit, and no jittering. 

The J19 has 2 chip select bits. How can I connect the additional 16 DOUTs? I will need them, so I have to findnit out. Is there any manual there? 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...