BrianS Posted May 4, 2020 Report Share Posted May 4, 2020 How do the DIN and DOUT boards identify themself with the core board? What I mean, is will the order of the boards not change after each power cycle? Quote Link to comment Share on other sites More sharing options...
Phatline Posted May 4, 2020 Report Share Posted May 4, 2020 dont matter - there are IN and OUT Lines, and they are connected thru the PCB... but put the DIN first, since it senses - and therefore it is more "sensible" Quote Link to comment Share on other sites More sharing options...
latigid on Posted May 4, 2020 Report Share Posted May 4, 2020 All that MIOS cares about is the position of the respective register in the chain. You can also run parallel chains of DIN/DOUT (no mixing in this case) by attaching three IDC plugs on the ribbon that attaches to the Core. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.