Layout Dual Mackie Clone

[doc]

Hi everybody,

by using some sparetime, I want you to have a look at my "working" layout of my MidiboxLc.

The Box will be used with Cubase and I "borrowed" a lot of things from the Mackie Controller and from Axels Midibox of the year.

It's not the final version but something near to it.

I just put the link here because of the filesize (about 500k). The image is quite noisy because of the high compression (the original file has 30 MB).

The original size is 1000 x 440 mm.

Any comments are welcome  ;D

http://www.systemhaus-schneider.de/doc/frontplatte3.jpg

Doc

[NorthernLightX]

Nice!

I would watch the screw-holes on the right side, by the Display/Aux/Page section, because they interfere with your graphics, I don't think you'll be able to print on a hole, are you?  ;)

[doc]

Thank you for the tip.

The screw holes must go away there I know. For this I have to change the PCB Layouts again .  ;D

Doc

[d2k]

Hey doc...

U know u can also use the ledrings as meters too right? Or u just goin for a uberl33t LC? :P

Peesh

D

[doc]

Hey D2k,

what is a "uberl33t" LC  ???

Yes I know, that the ledrings can be use. But I thought it is a good idea building both into the case. Who knows what tomorrow comes ... ::)

doc

[NorthernLightX]

Hi

uber = very (slang, derived from the german word for over)

l33t = leet = elite (slang for very cool, nice whatever ;)

I'm feeling like a walking dictionary right now  8)

[doc]

Thank you very much,

always ready to learn something new! 8)

DOC

[MrMusicman]

Hey Doc.

Nice Design.

But as I know Cubase does not support more than 1.

mackie controler (8ch), so if you will control 16 ch. you have

to use the "Generic Remote", but you will lose some

function and some thing will be harder to control.

good luck

Kent

[doc]

Hello MrMucicman,

thank you for your comment.

yes I know (now) that only one controller is supported.

But in a future release of cubase it will be supported.

(Don't want to drill again in the near future... ;D)

Doc