Antix

Hi, Probably , as say Altitude , the cheapest solution is the plexyglass you can buy in hardware store. If you have time with a dremel like tool you can engrave the edges to create a step to be embedded. Regards Antix

Hi, Does anyone experienced HCT14 Instead of HC14 on GM5x5x5? Saluti Antix

Bello, veramente bello. Beautiful, really beautiful. :D

Hi guys, Just tested on job in these days: Ethilic alchool whith a nails brush to remove flux after distilled water ( or demineralized water ) to remove any stains and streaks leaved by alchool. all these operation i made in little tanks but not submerging boards,I soak the brush and brush the board perpendicular to the liquid surface. I am very positively impressed from the result that is very very professional :thumbsup: Normally I use commercial flux cleaners ( very expensive ) so I think that it will be my stable method of cleaning, cheap and aesily available materials best regards Antix

Heya, PCB just arrived. Nice packaging and very nice PCB color. :drool: Thank You Seppoman Antix

Hi, Anyone used TL084 instead of 074? I am asking because i have a lot of 084 in my drawer and it will be fine use them. Thanks and regards. Antix

Hi I don't understand exactly your problem but I have burned just now four 16F88 with the last HEX file for IIC MIDI and returned any error you enountered.I suppose it is the ultimate firmware. I use EPIC programmer and PICPgm software. Hope you have already solved the problem. Regards Antix

Sorry for delay. On the bender board I have resoldered cursors ( pot ) and other SMD and PTH. The whole cause of malfunction was ( like old philips television ) a degradation of the PTH solderings. You can see , with magnifyng lens , like a little darker circle in the soldering around the pin. After resoldering pins of the cursors aftertouch starts ( restarts ) to work but I gave a little shot to all the soldering on this board. Regards Antix

Hi, Anyone knows why the styroflex ( polistirene ) cap haz a stripe on side? Normally ( what is normality in this world? ) a sidestripe on a el-part may indicates polarity. Regards Antix

Hi Seppoman, Mine is a "big order" too ? Regards Antix

Today I have mine too, Thank You TK

It is a beautiful MidiBoxSequencer :drool:

Ok, Thanks I am already sure for the pinning of the connector but not for the compatibility of the application with this board. You have cleared me. So the creative is the worst of the DBoard :hmm: anyway it is a pity put her in waste as I own and works well. :thumbsup: Is there a minimum of schematic for connecting to a core? I am searching on the forum in this discussion but i found only code file of app. Effectively it is a MB64 whith midi out connected to midi in of daughter but if exist a little schematic will be better. Thanks for any information best regards Antix