Revised 25-pin breakout port

[audiomobster]

Hello there,

is someone from Europe able to sell one or better two pair of these boards?

Best regards
Uli

[latigid on]

I have some, please PM for details.

[gohan2a]

hi, i want to send cv master clock, JCI port (mbhp line driver) are always planned?

[latigid on]

I don't understand the question sorry. Gates and clocks go through the DOUT (SRIO) chain.

[gohan2a]

I want to send cv clock at Midibox seq because some modular seq don't work perfectly when they receive clock and reset (slave), for live perf, it's important.

Tanks for fast reply.

[gohan2a]

Just now, gohan2a said:

I want to send cv clock at Midibox seq because some modular seq don't work perfectly when they receive clock and reset (slave), for live perf, it's important.

Tanks for fast reply.

• JCI port not used here (it's planned to use these lines for DIN Sync Clock and Start/Stop input in future)

[latigid on]

2 hours ago, gohan2a said:

• JCI port not used here (it's planned to use these lines for DIN Sync Clock and Start/Stop input in future)

Correct. Clocks and start/stop (i.e. "DIN sync") are sent over the DOUT shift registers. JCI is not used.

Check in the CV config:

Quote

• Clk: selects 1 of 8 clock outputs (available at a dedicated DOUT shift registered which has been configured with the CLK_SR parameter in the MBSEQ_HW.V4 file). Each clock has an individual clock divider, or can optionally be used to output a Start/Stop signal

 

[latigid on]

Ah, you want clock input. Not currently supported in the SEQ I think, but I believe it was done in the CV app? You can ask in the general firmware updates thread.

[strophlex]

Hello!

 

I got back to the synth hoby after a decade long hietous. Building a modular now and want to adapt my MB_SEQ 4 to able to control the modular via CV, so I need a transmitter and a receiver board. Anybodu have boards for sale? @latigid on?

Best regards!

[latigid on]

Hello and welcome back!

We have Eurorack-format modules here (including a "Euroceiver" board):
https://www.midiphy.com/en/shop/188/MIDIbox-Sequencer-v4+-Eurorack-Modules

and the line drivers in question:
https://www.midiphy.com/en/shop-details/0/10/linerx-pcb-
https://www.midiphy.com/en/shop-details/0/9/linetx-pcb-

Best regards,
Andy

[strophlex]

Wow! I missed all that new stuff! I build 5U with 15V (yusynth) so I miss out on all the nice euro-stuff. Now I will order those pcb!

Thank you!

[latigid on]

Welcome! The midiphy PCBs also have a standard IDC, so that means you can mount the PCB anywhere and use a ribbon cable to a breakout DB-25 anywhere on the case, if that suits better.