Jump to content

Revised 25-pin breakout port


TK.

Recommended Posts

  • 11 months later...
Just now, gohan2a said:

I want to send cv clock at Midibox seq because some modular seq don't work perfectly when they receive clock and reset (slave), for live perf, it's important.

Tanks for fast reply.

  • JCI port not used here (it's planned to use these lines for DIN Sync Clock and Start/Stop input in future)
Link to comment
Share on other sites

2 hours ago, gohan2a said:
  • JCI port not used here (it's planned to use these lines for DIN Sync Clock and Start/Stop input in future)

Correct. Clocks and start/stop (i.e. "DIN sync") are sent over the DOUT shift registers. JCI is not used.

Check in the CV config:

Quote
  • Clk: selects 1 of 8 clock outputs (available at a dedicated DOUT shift registered which has been configured with the CLK_SR parameter in the MBSEQ_HW.V4 file). Each clock has an individual clock divider, or can optionally be used to output a Start/Stop signal

 

Link to comment
Share on other sites

  • 3 years later...

Hello and welcome back!

We have Eurorack-format modules here (including a "Euroceiver" board):
https://www.midiphy.com/en/shop/188/MIDIbox-Sequencer-v4+-Eurorack-Modules

and the line drivers in question:
https://www.midiphy.com/en/shop-details/0/10/linerx-pcb-
https://www.midiphy.com/en/shop-details/0/9/linetx-pcb-

Best regards,
Andy

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...