tomcody Posted December 16, 2005 Report Posted December 16, 2005   In the Eagle Light file (mbhp_burner_v1.brd) there are some pads not connected to any wire, I observed the gif (mbhp_burner_v1.gif) and there are a groud area that is no there in the Eagle Light file (the program is showing me all the layers)... what's happen? ??? ??? ???.  Another question: I will use the Eagle Light file to make my PCBs: How I reduce the diameter of the pads and vias holes? ??? ??? ???. Thanks. Quote
TK. Posted December 17, 2005 Report Posted December 17, 2005 Hi,the ground area is not visible by default - it will be visible once you type the "rats" ("ratsnest") command. Changing diameters: type the "change" commandBest Regards, Thorsten. Quote
Jidis Posted December 17, 2005 Report Posted December 17, 2005 it will be visible once you type the "rats" ("ratsnest") command.Also, I think it will disappear again for some reason when you close or quit. Quote
tomcody Posted December 19, 2005 Author Report Posted December 19, 2005 Thanks to you Thorsten and Jidis. ;D ;D ;D ;D Quote
bellyflop Posted July 30, 2006 Report Posted July 30, 2006 Thanks to you Thorsten and Jidis. ;D ;D ;D ;DThis is an old thread, but I'm having this same issue after I type in the ratsnest command. Specifically, on the v1Plus board, one pad of R8 doesn't connect to anything. The other end is connected to pin 8 of IC3. Is there a schematic of this version of the board somewhere? It looks like the part numbers are all different compared to the first version. Finally, is the Eagle .sch file available? I searched for all this info, sorry if I missed it.Thanks!Dave Quote
TK. Posted July 30, 2006 Report Posted July 30, 2006 Could you please contact Mike and inform him about this error? (I also see, that one pin of R8 is open... compare it with the original layout to see how it should be connected)Best Regards, Thorsten. Quote
bellyflop Posted July 31, 2006 Report Posted July 31, 2006 Could you please contact Mike and inform him about this error?Assuming it's the ele*****ix00 @ aol.com address, I just sent him a message. Thanks Thorsten. DaveEdit: for what it's worth, this appears to be the needed correction. It shows up as an unrouted connection at C6. Quote
Altitude Posted August 4, 2006 Report Posted August 4, 2006 um, what board is that? Those values do not correspond the the mhbp_burner_v1.brd file i have (its R10 and C8 on mine, and they do connect) Quote
TK. Posted August 4, 2006 Report Posted August 4, 2006 It's the *_plus.brd file - Mike will send me a fixed version in the next daysBest Regards, Thorsten. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.