Jump to content

Recommended Posts

Posted

Thank you. I remember I've seen somewhere at the forum some info about core32 sid (how much SIDs can be connected, etc). But searching for

sid mios32

and

sid core32

didn't give any results.

Posted

There is currently no advantage if you build this incomplete (!) version - the project is stalled as long as no STM32 derivative with 512k flash and simultaneous access to CAN and USB interface is available.

The V3 firmware was only "prove of concept" and some personal C++ practice. It could take another year until it will be continued - or maybe I should just cancel it and focus a new synth? :ahappy:

Best Regards, Thorsten.

Posted

based on CEM3396 if i offer you the chips ? :flowers:

+1oneoneeleven!!!!111

As long as the ST32 outputs the correct timer signals to the 3396's waveform converters we are gold.

Me on this: Stalled for now :(

Back to Xcode.

  • 6 years later...
  • 3 weeks later...
Posted
On 12/29/2010 at 3:20 PM, jojjelito said:

+1oneoneeleven!!!!111

 

As long as the ST32 outputs the correct timer signals to the 3396's waveform converters we are gold.

Me on this: Stalled for now :(

 

Back to Xcode.

How bout the 3372 too?? :D

Posted

There's nothing magic in the CEM3372. Some other CEM chips also support pole switching. Some, like the CEM3378/79 don't do it as easily. Better leave them for spares for the good old stuff like Chroma Polaris and such.

If you want to see pole mixing done with readily available components you could take a look at the 4 Pole Mission Shruthi. The Ambika didn't realize a full version of that due to component count/cost, but it can certainly be done.

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...