technobreath

What do u mean by that? :). Does the trønder know why the tubes are laid out this way at all? hehe.

Oh I just love this. The white, matte, almost a little transparant material - it's just... mmmmmmmmmmmm

Bag on the window is there because it's broken. And why state this obvious fact? My grandma who lives in the house for the time being forgot to bring her keys and locked herself out. When she got home, she knew I was about to replace that window anyway, so what did she do? Crushed it, removed all glass from the frame (till she bled) and crawled in :D haha. it's about 30x35cm hole.

Oh I need this material for my mb6582 front panel :) Looks nice!

I'm drawing up some schems for this IC based solution now. This IC seems very promising the more I look into it. However, I have certain issues trying to wrap my head around how it really works. I'm soon there though ;). This chip, however is particulary interesting since it can do voltage window comparing. The undervoltage condition detection is a really interesing bonus. I'll try and come up with a design that trigger the SCR at precise over voltage conditions, and also a autoshutdown of all rails at under-voltage condition. I have done an experimental PSU schem some months ago to learn about how to achieve these functions using basic components. The huge drawback to this was that the design had much more discrete components, and many comparator ICs. It also provided seperate vref from a seperate ciruit. This IC seems to have all of this built in, and I only need 3 resistors for each of the ICs to set the window for it to operate in normal state. This IC also makes it easier to incorporate these status LEDs jojjelito asks for, though I'm not sure how interesting such leds really would be. A single LED that is green when all rails are operational and that is red if a fuse is gone would probably be enough for me. Those 5x20mm glass fuses is easy enough to visually confirm broken or not. I try to keep the design as simple as possible... In the final design I will pobably use panel mount fuse holders, to make it way easier to change them if they blow. Any ideas to this IC based design is very welcome.

Clone of your crowbar ;) Though on my quest for perfection I found a IC to more acuratly control tripping of the crowbar. I'm sure it's all hysteria and lots of over-perfection talking, but I read all over the net that this basic circuit is kinda hard to control at very low voltages... But I'm sure it works fine :) hehe. But just for the fun of it I'm exploring IC based design for this as we speak... lets see how it turns out.... datasheet for the IC: http://www.onsemi.com/pub_link/Collateral/MC34161-D.PDF